INFORMATION

 

TYPE OF BLADES FOR DIFFERENT CUTTING

 

SLASHING      2 or 4 Stepped Blades on each rotor

slashing blades

info slashing

CUTTING        2 or 4 Stepped Blades on each rotor

cutting blades

info cutting

MOWING/WINDROWING   2 Twisted Blades on each rotor

info mowing windrow mower

TOPPING        2 or 4 Stepped Blades on each rotor

topping-blades

info topping mower

MULCHING/STUBBLE  MULCHING     2 Stepped blades &  2 Angle Blades on each rotor or 4 Stepped blades on each rotor

info mulching

BLADE INFORMATION

ARE YOU USING THE RIGHT BLADES?

  1. Loxton Engineering blades are made out of hard wearing steel then bent/twisted, heat treated, tempered to the right Rockwell hardness. Blades are check for length, bend or twist in blade, paired and weigh for balance. Rockwell hardness is an Australian (World) metal hardness standard required for forged/metal steel for long wearing life. If blades are too hard then they can chip or brake and if blades are too soft, blades will wear quickly, bend, and damage blade and blade edge.
  2. Blades disadvantages ( thicker millimeter).  Thicker Blades blunt a lot Quicker, more Horse Power (PTO revs) required, not as clean cut and cost more
  3. Blade cutting edges. A pressed edge does a cleaner cut and stays sharper longer than a laser edge, plasma edge, oxy edge or milled edge.
    cutting edge 1
  4. Twisted blades stay sharper longer due to the twist in blade (self-sharpening)
  5. Incorrect Blade hole position and hole size in relation to the end of blade, can cause bush and hole to wear more quickly. Blade hole to close to end will increase hole wear in blade (extra blade length on top side of hole will help keep blade more level hence less wear on bush, blade hole and bolt. Bush sizes have similar wear factors.

hole positions